Back
3DSEARCH / Organizers / Strong under-mount hook
Strong under-mount hook – 3D printable model from MakerWorld MakerWorld
Organizers

Strong under-mount hook

by Steve
127 Downloads
29 Likes
69 Makes
Download Model
hook strong no support petg diy organize home tools practical simple functional plant hang hanging houseplant
Simple under-mount hook oriented for printability and strength. Fasten from below up into your surface with two screws. No supports needed. Reduce wall count or infill % for faster print time at the sacrifice of strength. Approx. dimmensions:~30mm wide~100mm deep~115mm tall Boost MeGot a boost to spare? I'd love to put it to good use if you appreciate this model!
Category
Organizers
Source
MakerWorld
Published
06.03.2024
Updated
06.03.2026
Comments
0

Comments

No comments yet – be the first!
More Organizers Models All MakerWorld Models More by Steve

Similar Models

6 Suggestions
Key or Lanyard holder with label slots
Key or Lanyard holder with label slots
by CodeFox
Easy Print Super Strong Hook - Single Piece - No Screws - No Supports - HSW Honeycomb Storage Wall
Easy Print Super Strong Hook - Single Piece - No Screws - No Supports - HSW Honeycomb Storage Wall
by KYZ Design
↓ 3.5k ♥ 765
Clamp-On Headphone Hook – Adjustable Under Desk Headset Holder (No Supports)
Clamp-On Headphone Hook – Adjustable Under Desk Headset Holder (No Supports)
by gumustendesign
Headphone desk holder (no screw but very strong !)
Headphone desk holder (no screw but very strong !)
by Benoit
↓ 137 ♥ 10
Simple & Strong Hook
Simple & Strong Hook
by RESTLESS DESIGN
↓ 11.2k ♥ 4.4k
Simple & Strong Hook - V3
Simple & Strong Hook - V3
by RESTLESS DESIGN
↓ 450 ♥ 105

Add to Collection