Stubby Magnetic Bit Driver Handle

Maybe you have already seen my Magnetic Bit Driver Handle. Now here is an alternative version: The Stubby Magnetic Bit Driver Handle Features:Can be used with every 1/4'' (6.35mm) standard bitBits are hold in place by a Ø4x2mm magnetThe clip-on endcap rotates for easy operationFour small standard bits can be stored in the handlePrintable in multicolour or single colour (so, AMS is optional)Only needs 28gr filamentPrint preparation:Make sure that your print bed is clean and grease-free and use a quality brand and dry filament. If you are having bed adhesion issues you can always try the new Bambu SuperTack plate (do not forget to change the plate in slicer). Print settings:Use the 0.2mm standard settings for everything. Support should not be needed, but you can add tree support for the magnet position in the handle. All my test prints were ok without support, so my profile is without support. A brim for the handle is recommended to increase the bed adhesion. Set the wall number