Stubby Magnetic Bit Driver Handle

Maybe you have already seen my Magnetic Bit Driver Handle. Now here is an alternative version: The Stubby Magnetic Bit Driver Handle.


Features:

Can be used with every 1/4'' (6.35mm) standard bit
Bits are hold in place by a Ø4x2mm magnet
The clip-on endcap rotates for easy operation
Four small standard bits can be stored in the handle
Printable in multicolour or single colour (so, MMU/AMS is optional)
Only needs 29gr filament


Print preparation:
Make sure that your print bed is clean and grease-free and use a quality brand and dry filament. A quality filament is necessary because the seat for the magnet has tight tolerances.


Print settings:
Use the 0.2mm standard settings for everything. Support is not needed. A brim for the handle is recommended to increase the bed adhesion. Set the wall number to four for a robust print. 12% gyroid infill should be enough.
See my 3mf print profile (Orca Slicer or Bambu Studio) for details.


Assembly:

Optional: Install three Ø4x2mm