Stud-Mounted Spool Holder

This is a spool holder that can be mounted on a stud.
Additional parts required:
* M8 150mm bolt
* 3 M8 nuts
* 2 608 bearings

Instructions:
1. Print all parts.
2. Insert the bearings spacer into the main holder part.
3. Push the 2 bearings from the 2 sides of the holder.
4. Insert the M8 bolt from the side where the spool is mounted.
5. Secure the bolt with 2 nuts on the other side.
6. Insert the bolt into the clamp.
7. Secure the bolt with another nut from the other side of the clamp.

SpoolHolderMain
This is the main part of the spool holder that holds the spool.

Print Settings:
Layer height: 0.2 mm
Wall line count: 5
Infill: 20%
Z seam alignment: Random
Supports: Required, but block supports on the thread
Filament: PLA/PETG (PETG should be more durable)

SpoolHolderNut
This is the nut that holds the spool on the holder.

Print Settings:
Layer height: 0.2 mm
Wall line count: 5
Infill: 20%
Z seam alignment: Random
Supports: Not needed
Filament: PLA/PETG (PETG should be more durable)