Sturdy moss pole (parametric)

Made for climbing plants like monstera, photos, or ivy. Note: you will need a rod, wooden dowel or similar for this print. My monstera was falling over because of its size. I decided to kill two stones with one bird and made this design. The printed part is essentially a cage to keep sphagnum moss in, which the plant can set air roots in and climb on. By sliding the print onto a pole (shoved into the soil as deep as your pot allows), you get a sturdy support that looks pretty, will keep your plant happy (probably), and is expandable. The model I printed is made for a 26.5mm rod, because that is what I had at home. I will add print profiles for common diameters from like Home Depot or Amazon, but let me know if you have need for a specific diameter and I'll try and upload a for you c: The pillars can be attached to each other by aligning the top tabs of one with the bottom slots of the other. You will need one printed cap as well, otherwise the support will be weak. Parametric desig