Thingiverse
Stylish Guitar Hook / Stand / Wallmount
von LordGrantham
18
Downloads
17
Likes
0
Makes
This is a simple, but strong, guitar wall hook designed in 3DS Max.
I have attempted to make a simple hook using as little non-printed materials as possible.
To build this you will need 4 M6 Nuts and 2 short M6 Rods - cut to length.
The cut lengths of the M6 Rods are 1x 4.4cm 1x 5.3cm approx. I have used low profile M6 Nuts, but you might get away with standard height ones.
I have attempted to make a simple hook using as little non-printed materials as possible.
To build this you will need 4 M6 Nuts and 2 short M6 Rods - cut to length.
The cut lengths of the M6 Rods are 1x 4.4cm 1x 5.3cm approx. I have used low profile M6 Nuts, but you might get away with standard height ones.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!