Stylish Headphone Holder

I created this headphone holder from scratch in Freecad. The black is Flashforge black silk PLA and the highlight rings are Iksystem Red/Gold PLA. It doesn't require the AMS as the black and color highlight can be printed on separate plates. Total print time on a P1S is around 11.5 hours. Because of the vertical threaded rod, I wouldn't advise trying to print this on a bedslinger. You can print all the black portions on a single plate if you choose but that only cuts a little time off the print. Minimal supports are needed to print the top piece and the threaded rod needs a brim. I printed the base at a 0.16 layer height and also used adaptive layer height. The base was printed with 40% infill for heft and, as shown in the pictures, four rubber feet were added on the bottom so it won't slide aroundBoost MeI'm still learning so I welcome feedback and boosts are always very much appreciated.. You can reduce the infill percentage to speed up the print if you like. The rest