Thingiverse
SUBARU EJ20 COIL PACK REMIX
von pockethome
1
Downloads
2
Likes
0
Makes
This is an optimization of the ignition coil。
Modify the drawing so that the connection installation part is complete and looks completely sealed。
The connection position between the mounting buckle and the cylinder block is magnetic suction。
magnet:2-2mmX1mm---Mounted in the cylinder block position
2-2mmX2mm---Mounted in the snap position
Note: Even if you don't install a magnet, the fit is still tight, it won't come off, and it may need to be slightly polished depending on the printing accuracy
Modify the drawing so that the connection installation part is complete and looks completely sealed。
The connection position between the mounting buckle and the cylinder block is magnetic suction。
magnet:2-2mmX1mm---Mounted in the cylinder block position
2-2mmX2mm---Mounted in the snap position
Note: Even if you don't install a magnet, the fit is still tight, it won't come off, and it may need to be slightly polished depending on the printing accuracy
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!