Slicer Discord
Subwoofer enclosure – 3D-Druckmodell von MakerWorld MakerWorld
Music

Subwoofer enclosure

716 Downloads
300 Likes
39 Makes
Zum Modell
This is an enclosure for the Tang Band W3-1876S Sub woofer that will bring a serious amount of low end bass to your listening experience.With the correct DSP or cross-over you can enhance your listening experience without sacrificing space.The enclosure dimensions are as follows:240mm x 240mm x 121mm heigh. Optional extra:I include in this file the complete sub enclosure and also a amp box which is designed specifically for the DollaTek XH-M180 50Wx4 TDA7850 amplifier. This amp box also accommodates the ADAU1401/ADAU1701 DSP board too for audio correction. If like me you are looking for a small form factor sub woofer to bring an extra dimension to your audio listening experience then look no further. Tang Band have gained a reputation for seriously good speaker drivers and the Tang Band W3-1876S Sub woofer is no exception. Check out you tube if you don't believe me!
Kategorie
Music
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen