Succulent Planter or Small Case

Updates
03/03/2022
I thought it might be nice, if these were being used as containers instead of planters, if they could stack. I therefore did a slight revision of the model and made them stackable. I have left the others available if needed.
If you need to print with a line width of 1.2 mm they will still fit but will be a little tighter than with 0.75 line width.

I have also added a new design at the same time. K8 may also need to be printed at 1.2 line width to ensure that there are no gaps in the sides but I have not tested this with narrower line widths.

I had a slight problem with my computer and lost a few of my files so some of the new designs are not exactly the same as the older versions.

03/02/2022
I added a base for using with the planters. It is already resized @110% and it is hollowed out so that it can have the small risers to assist with drainage. This part can still be printed in spiralize mode as long as enough bottom layers are given to print to just ab