MakerWorld
Hueforge & Lithophane
Zum Modell
Sugar Maple HueForge
75
Downloads
49
Likes
30
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.08mmThe Model is 200x133.33mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mmFilaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #9 (0.72mm) swap to Red At layer #14 (1.12mm) swap to Orange At layer #21 (1.68mm) swap to Yellow for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!