Slicer Discord
sugar rocket – Modelo 3D imprimible de Thingiverse Thingiverse

sugar rocket

por cyryz
0 Descargas
0 Likes
0 Makes
Ver Modelo
a sugar rocket requires a launch rod 10 mm or smaller flies about 300m fully packed. also i use a 75 35 ratio of 75 potassium nitrate and 35 sugar

to use:
put rocket fuel in the back BEFORE putting the nose cone on

then pack the rocket fuel repeat 2-3 times till about 2cm and then get the nozzle put super glue ALL over the outside and put it in with the LONG side facing in so the short side is on the outside of the rocket. - if the nozzle is a tight fit tilt it on a 45 degree angle put it in then grab a hammer and hit it till it moves and becomes flat

put the top on

then put the fuse or sparkler in the bottom, slide the rocket down light it and RUN this could explode so go far and watch it woosh.

(by the way it would be nice if you commented that it worked for you and if not i can change the design)
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Pegado
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección