Sumie Hueforge Decor

I have two seperate print files for AMS users. So you dont have to worry about filament changes. But if you dont have AMS you can use this settings and filament swap instructions. For the piece on the left, designed to be a bookmark use this settings.Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mmThe Model is 70x124.4mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2mm and the Actual Depth is 2mmFilaments Used: PLA+ Esun Black Transmission Distance: 0.4 PLA+ Uzy Red Transmission Distance: 5.4 PLA+ Esun Bone White Transmission Distance: 5 PLA+ Esun Cold White Transmission Distance: 2.4This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #14 (0.68mm) swap to Red At layer #17 (0.8mm) swap to Bone White At layer #45 (1.92mm) swap to Cold White for the rest. For the piece on the right, use this settings: Swap Instructions: Start with Black At layer #14 (0.68mm) swap to Red At layer #15 (0.7