Slicer Discord
Summoner Wars Deck Box – 3D-Druckmodell von Thingiverse Thingiverse

Summoner Wars Deck Box

0 Downloads
1 Likes
0 Makes
Zum Modell
This is a box that's made for a single commander deck for the card game Summoner Wars! The reason I say it's specifically for that is because it's designed to hold 34 cards (The exact number that's in a standard deck for the game) in Dragon Shield Card Sleeves, with just a little bit of wiggle room to comfortably take the cards in and out!

For settings I'd highly recommend keeping layer height between .20 and .18, as I've found that with .16 and below the lid is a little too loose and the cards could come spilling out.

I might make an updated version in the future where the back of the SW cards are on the actual deck box, but for now I think these are a fantastic start!
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
Supports nötig
Einteilig Supports nötig
Supports 2/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen