Thingiverse
Sun and Sails
von Skyblue
27
Downloads
33
Likes
0
Makes
Faux stained glass-light catcher. Printed in ABS @.3mm.
I used some acetone to glue pieces into recesses in frame.
PLA users could use white glue.
Note: My faux stained glass models are scaled for 8 x 8 platform.
If you re-scale, pieces might be too small to handle. Also if made smaller, you must ensure that your "glass" pieces are at least 2 layers thick after slicing. Frame prints upright, pieces print upside down, flip pieces over and insert into upright frame.
I used some acetone to glue pieces into recesses in frame.
PLA users could use white glue.
Note: My faux stained glass models are scaled for 8 x 8 platform.
If you re-scale, pieces might be too small to handle. Also if made smaller, you must ensure that your "glass" pieces are at least 2 layers thick after slicing. Frame prints upright, pieces print upside down, flip pieces over and insert into upright frame.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
