Sundara Wall light

I'm always excited to release a new design, this one fought back that much I'm a little relieved its done and I couldn't be happier with it. This is our first experiment with fuzzy skin and we will be adding this tool to our bag for things to come. Its also our first multi part build that uses interference fit (ish) and requires no glue to build. Build as per below, 1, Thread Kapplake wire through the square hole at the bottom. 2, The connector for this is a snug fit inside the Kapplake holder conduit and will need some effort to push it through at the top (I use a small old blunt flathead screwdriver placed alongside the cable in the hole against the connector body and push it through with that) 3, Connect the cable to the Kapplake LED then slot this in the hole light side down, don't rush this bit as its a tight fit it should pop in past the raised lip on the inside. 4, Gently wiggle this assembly into that bottom hole until the top tongue and groove joint are lined u