Sunfish/Laser Mast Holder

This is a mast holder set to allow you to transport your mast/boom/sail for a sunfish, laser, or similar dinghy, without damaging the hull in transit. The forward section drops into the mast tube and allows for a ratchet strap to wrap around the mast and then go down the the trailer. The rear section goes aft of the cockpit and sits on top of the deck, again with holes for tie down/ratchet straps. I recommend cork or felt padding be added to the base to protect your finish/gelcoat.

I recommend printing in PETG, TPU, or ABS for structural integrity and flexibility on the road under pressure. The front piece is best printed on its side, but the rear should print fine upright.