Sunglasses Case

An easy sunglasses case with sliding lid! 😎AssemblySlide the door into the tracks in the case through the gap on top.Test fit the umbrella silhouettes into the end. Note the orientation.Apply glue to the back edge of umbrella silhouette. Any or all of the areas in green are good. Be careful not to get glue into the red portion that contacts the sliding door. Press the silhouette into place.Repeat for the other side.Tips: CA adhesive accelerant and gel CA glue makes the job much easier and prevents the white vapor ghosting that CA is prone to.It doesn't take much glue. Try to get a bit on the thinner sections and a good sized dot on the back of the umbrella and you should be good. Boost MeLike this case? Send me a boost!😎😎MembershipWant to sell these? Join my commercial license membership!😎😎