Thingiverse
Sunglasses Stand - Single
door Duffr75
5
Downloads
7
Likes
0
Makes
This is my attempt at duplicating the old metal Oakley display stand. I used an actual display stand for dimensions and used Tinkercad for the design. Added some rivet looking bumps on the base for aesthetics. Also added indexing pins on the back for assembly.
Uses an M3 x 10 screw and nut to hold it together. Could also be super-glued I suppose.
The back of the model is prone to cracking, so I made it a little more thick. It'll still crack if you put too much pressure on it. You can use PLA, but it'll be much more sturdy if you use PETG.
Uses an M3 x 10 screw and nut to hold it together. Could also be super-glued I suppose.
The back of the model is prone to cracking, so I made it a little more thick. It'll still crack if you put too much pressure on it. You can use PLA, but it'll be much more sturdy if you use PETG.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
