SUNLU 2S Mounts for Snapmaker 2.0

This is a two-part mount for the SUNLU S2 print dryer on the Z-axis of my A350T. The feet on the S2 have enough of a slightly snug fit in the pan so I can move the printer on its cart without tipping the dryer(s). I built my setup for the dual extruder, which I still have not mounted. One could mount the dryers higher on the Z-axis but I needed clearance under a bar in my closet. Note that the brackets have a raceway at the Z-Axis for power (and emergency kill switch on the power side).

If you go with the Dual Extruder setup as shown, depending on how you route the print head power, the facia part may or may not be necessary. I needed it because I have mounted the brackets for a tool head power chain, but have not mounted the chain itself. The cord liked to get hung up on the chain brackets. For me, the facia was an afterthought, and I mounted it with a bolt and nut through front of each pan. A more elegant solution could have been used.

I used 4 M4x20mm socket head cap