Sunlu Batman Filament Guide

Thanks to Dijo for the idea. I also had to move my filament above my printer because of the enclosure. This is a Remix of his design. I added the Batman Logo under his design. I used Black PLA and the Shiny Silk Red on top of it. I used Tree Supports under the design and was a bit tricky to remove but it worked out well. There is a tab on the underside to line up in the hole for the Sunlu Filadryer but I ended up removing it and aligning up the holes to drill for the 3mm by 10 screws.
I am probably forgetting to add something in this. This is my first make and post on Thingiverse.
I used Tinkercad to do the Remix, The Slicer is in Cura 4.8