Sunlu mini spool AMS lite adaptor

I bought some Sunlu filaments - 250 g, not realizing the mini spools had a smaller 42mm diameter.I did not want to respool.I made this adapter (actually 2 pieces) that uses the AMS lite spool holder.You do need to take the claw arms off and the bearing base.This file will print a hollow cylinder (no slots in final) that the spool base will connect too. Depending on spool tolerances the printed cylinder may be a tight fit. Then the internal spool holder drive goes in and clips back onto AMS lite unit. Be sure you know where yellow and green go. Then the printed cap uploaded also presses on to the end. Not the prettiest as I'm sure I could tweak it but it is working well.I did buy another set of spool holders for ease of switching to regular spools. Sunlu mini spool ams lite adaptor