Sunlu S2 holder

Made this shelf for my Sunlu S2 dryer but was asked for the file,
since i made this specific for mounting around my table leg, i modified the file to mount against a wall or plate.

Printed everything without supports.

The top ptinted upside down with flat plant on the printbed, if you have good bridging you dont need support, but if you're not sure, u can use "tree support" touching buildplate and you are safe.

For the mounts you should place them on the flat side on your bed also no supports 20% infill Grid.

I filled the holes with some clay from my daughter (lol) for extra stability.