Thingiverse
Super Bang Dart
von A1ex101
15
Downloads
11
Likes
0
Makes
The 'Super Bang Dart' is a throwing dart designed to make a large POP! when it lands on a hard surface.
*****ASSEMBLY:*****
1. Cut the base and sharp end off of your nail with pliers or bolt cutters (size shown above)
2. Slide the tail onto the nail and glue
3. Slide on a weight or nut with an offset of about 4-5 mm from the tip, then glue
(I found that two nuts =~ .10 oz works best)
4. Load super bang cap onto tip and throw in a safe direction
*****PLEASE DON'T THROW AT OR NEAR ANY PERSON OR ANIMAL*****
*****ASSEMBLY:*****
1. Cut the base and sharp end off of your nail with pliers or bolt cutters (size shown above)
2. Slide the tail onto the nail and glue
3. Slide on a weight or nut with an offset of about 4-5 mm from the tip, then glue
(I found that two nuts =~ .10 oz works best)
4. Load super bang cap onto tip and throw in a safe direction
*****PLEASE DON'T THROW AT OR NEAR ANY PERSON OR ANIMAL*****
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!