Super clean Octoprint setup with camera holder

I got sick of the awkward camera mounts, and the long cables, the sloppy look, lack of access to the Raspberry Pi so I designed this simple setup. This puts your Pi, and camera all in one nice clean little package. The installation is pretty straight forward you can see from the pictures. 2 key things, first when you install the nuts you can get them started on the screw and just let the screw pull the nut in, it will catch itself on a corner and seat right in perfectly. 2 make sure when you install the video cable the blue side of the cable is on the side of the lock usually, also the fit through the top case is rather tight but it will fit. Reuse the bolts that came out of the motor cover, be aware the servo is going to drop out a bit when you take it loose as nothing will be holding in it. The screws I used for the rest of the installation were M6.

You will need 3 socket head M3 nuts, and 3 M3x20 screws, you will need 5 M4 nuts, and 5 pan head M4x9 screws.


If you find the M