Thingiverse
Super Hero Ear savers
door feanorgem
222
Downloads
159
Likes
0
Makes
These are colored, by layer, superhero logo ear savers. They are a remix of many sources from Thingverse. They are set up to use a common configuration using the Multi-Material 2S but could be printed by swapping filaments at the layer changes on a single color printer. The color load pattern 1-5 is: blue, red, yellow, white, black but none of the prints uses all five, typically just two or three. File names containing "Top" print two copies on the top half of the print bed while those containing "Bot" print two copies on the bottom half of the print bed, thus you can run any combination of Top and Bot without removing anything from the print bed. You can increase the quantity printed by adding more instances and arranging them so they fit.
feanorgem publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
