Super Mario Firepower

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size You may print at higher layer heights below the Base Thickness of 0.72mm The Max allowed Thickness is 3.76mm and the Actual Thickness is 3.6mm #0f1821 PLA Sunlu Black Transmission Distance: 0.1 #9b9ea0 PLA BambuLab Matte Ash Gray Transmission Distance: 1.5 #ffffff PLA BambuLab Basic Jade White Transmission Distance: 5 #ce2029 PLA ESun Fire Engine Red Transmission Distance: 4.7 #ff9016 PLA BambuLab Basic Pumpkin Orange Transmission Distance: 5.5 #fec600 PLA BambuLab Basic Sunflower Yellow Transmission Distance: 4.4 This print uses 6 unique filaments Swap Instructions: Start with Black At layer #14 (1.2mm) swap to Ash Gray At layer #18 (1.52mm) swap to Jade White At layer #28 (2.32mm) swap to Fire Engine Red At layer #38 (3.12mm) swap to Pumpkin Orange At layer #41 (3.36mm) swap to Sunflower Yellow for the rest. If you are looking for a frame I use these by user dawm 200x200 fram