Thingiverse
Super Mario Shining Star
by blecheimer
37
Downloads
43
Likes
1
Makes
It is getting close to christmans and I was looking for some decoration. So I made a Super Mario Shining Star.
The star is hollow and has a groove for a 12V LED strip (~10mm width). I recommend a strip with 60 LEDs/m. I have used 120 LEDs/m and it is way too bright in my opinion.
Some strips generate a significant amount of heat. In this case you can use the "frame with vents". This frame has some holes which allow air circulation.
Print the star's sides at a layer hight of 0.2mm. The frame, the eyes, the pole and the stand can be printed at 0.3mm layer height (or better). Use support on the frame.
You might want to paint the seam of the stand in black to give it the look from the game.
Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0.
You are not allowed to copy this model to other 3D printing websites without my permission.
The star is hollow and has a groove for a 12V LED strip (~10mm width). I recommend a strip with 60 LEDs/m. I have used 120 LEDs/m and it is way too bright in my opinion.
Some strips generate a significant amount of heat. In this case you can use the "frame with vents". This frame has some holes which allow air circulation.
Print the star's sides at a layer hight of 0.2mm. The frame, the eyes, the pole and the stand can be printed at 0.3mm layer height (or better). Use support on the frame.
You might want to paint the seam of the stand in black to give it the look from the game.
Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0.
You are not allowed to copy this model to other 3D printing websites without my permission.
blecheimer also publishes on
235 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
