Thingiverse
Super Simple Snapmaker Laser Test
by sdj544
180
Downloads
79
Likes
0
Makes
A very simple laser test. This was made in Snapmaker Luban for a Snapmaker A350.
Not sure how it will work on other laser machines. Try it out and let me know.
It cuts lines from 10% to 100% power @140mm/min, 2 passes, 0.6mm pass depth (vector)
Grayscale squares from 5% to 100% black using both the stock greyscale (normal quality 7 dot/mm, 500mm/min) and b&w (4 dot/mm, 800mm/m) settings.
Test shown was done on 1.6mm baltic birch. As you can see it cut through cleanly on several of the cutting tests.
(second try at publishing this. First try shows up if you use link, but not when searching)
Not sure how it will work on other laser machines. Try it out and let me know.
It cuts lines from 10% to 100% power @140mm/min, 2 passes, 0.6mm pass depth (vector)
Grayscale squares from 5% to 100% black using both the stock greyscale (normal quality 7 dot/mm, 500mm/min) and b&w (4 dot/mm, 800mm/m) settings.
Test shown was done on 1.6mm baltic birch. As you can see it cut through cleanly on several of the cutting tests.
(second try at publishing this. First try shows up if you use link, but not when searching)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
