Super Simple Spool Holders!

These are nothing special but they're very handy. Most of the holders on here require PVC pipe etc but I wanted something totally 3d printed so I designed these. I'm always swapping spools and looking for a spot to store them, even temporarily sometimes between prints.. I had a stack of 5 spools while I was making these. Originally I was just going to do a tabletop version since that's where I'm always stacking them and then I decided to make some wall mounts I and really like them, but I do still have a few on the table since it took my about five tries to get these right and I have several extras.. One section will hold three spools, they're 220mm long, and the sections slide together. You can use one, two or as many sections as you'd like, like my never ending shelf.. For best results lay them on a flat surface and glue them together so they don't sag, if you use the wall mounts, on a shelf or table they'll be fine and easily disassemble for storage.