super soaker with CPS

since the super soaker brand got nerfed, and the bad ass super soakers of my youth are no longer sold, I had to take matters into my own hands.

The chamber core, pump core, bottlecap holder and nozzle were Resin printed, the rest is FDM. You will need a CR10 sized printer for a lot of these parts.

it uses PVC pressure pipe and fittings, as well as 1/4" push to connect tube and fittings for the internals. I used some 1/4" barb fitting check valves from amazon to make the pump.

It uses your classic air compressor blow gun for the trigger valve, like this one: https://www.harborfreight.com/blow-gun-with-safety-tip-and-rubber-tip-63577.html.

Here is how the pressure chamber works:

One side of the PVC tube has a water inlet (1/4" push to connect fitting) one side has a a presta valve core (like for a tubeless bike tire), between them is the chamber core, which has some O rings and grease, which allows it to slide up and down the tube, but separates the two ends from each ot