Superman lamp - LARGE

Added visual installation instructions, SPECIAL THANKS TO BEN:TIP: first connect the wire to the seal and install the seal cover and install the bulbsocket at the end just before installing the superman cover.Use PETG or ABS, ASA to avoid warping of the light due to heat.Glow in the dark filament for bonus effect when turned off.Use a LED light bulb (I used 8W which gives sufficient light in my case).Glue parts with contact glue or superglue.I added L-profiles to assist in easier glueing of the S-shells and the S-shell to the main top shell.the contour frame could maybe be resized so they are 0.5mm larger than the file. This will make sure the frames show no intermediate gap. Enjoy! PS: there is also a smaller version: https://makerworld.com/en/models/56174-superman-lamp-small