MakerWorld
Hueforge & Lithophane
Go to Model
Superman Sixties
0
Downloads
0
Likes
1
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 105 x160mm in sizeYou may print at higher layer heights below the Min Depth of 0.88mmThe Max Depth is 2.2mm and the Actual Depth is 2.3mm Filaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA PolyLite Grey Transmission Distance: 1 PLA BambuLab Basic Yellow Transmission Distance: 5.9This print uses 4 unique filaments Swap Instructions: Start with Black At layer #12 (1.04mm) swap to Blue Gray At layer #17 (1.44mm) swap to Grey At layer #24 (2mm) swap to Yellow for the rest.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
