Supermarine S6B

A nice little display model (36 cm wingspan) made after some questionable quality blueprints I've found on the net. -So it's obviously not so accurate. :)
The rectangular holes are roughly the size of an average round toothpick, this should help positioning the larger parts while the glue dries.

None of the parts are larger than 18cm, so they should fit into any average sized printer. The one you see on the photos was printed from clear PLA on a 0.35mm nozzle Leapfrog Creatr, using support only for the nose.

Enjoy!

Note: As it was pointed out recently by DDW96, the propeller was symmetric. This has been corrected.