Thingiverse
Supernote Stylus Stand
por kitlaan
5
Descargas
3
Likes
0
Makes
A vertical stand for the Ratta Supernote (Standard) Stylus. Gets it off the table so it can be picked up easily and also so it doesn't roll around (not that it rolls much before).
As pictured with 0.1mm layers, but it also printed properly with 0.2mm layers. The tolerances are "just right", so if your printer is over-enthusiastic, you may need to scrape at the inside a little.
As pictured with 0.1mm layers, but it also printed properly with 0.2mm layers. The tolerances are "just right", so if your printer is over-enthusiastic, you may need to scrape at the inside a little.
kitlaan también publica en
50 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
