Thingiverse
Supernova E3 Handlebar Adapter
door funkyluke
2
Downloads
2
Likes
0
Makes
2023 Update:
widened to 12mm and improved geometry on clamp. now uses a M4 screw to close.
Fitment is quite tight, if it is too small to fit your handlebar dremel it out or print at 102~105%
This is a handlebar mount for the standard E3.
It is made for 31.6mm Handlebars and is probably a bit on the tight end - you may need to sand it a bit to fit properly.
Needs a Ruthex or similar M3 threaded insert.
widened to 12mm and improved geometry on clamp. now uses a M4 screw to close.
Fitment is quite tight, if it is too small to fit your handlebar dremel it out or print at 102~105%
This is a handlebar mount for the standard E3.
It is made for 31.6mm Handlebars and is probably a bit on the tight end - you may need to sand it a bit to fit properly.
Needs a Ruthex or similar M3 threaded insert.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
