Thingiverse
(SUPERSEEDED) Anycubic Mega Hotend Cable Guide
por IJK_CZ
22
Descargas
17
Likes
0
Makes
Note: This version is replaced by new one : https://www.thingiverse.com/thing:5390271
The reason was, the original version limited the usable printable high to 200mm. The new version allows to use full printing space 210x210x205mm
If you do not use maximum high, you can continue use this version. But for new prints, or to exclude the limit, use the new design.
Cable and bowden holder for Anycubic Mega /Mega S. Easy to print and use. It prevents cable and bowden contact with ramp, when the printed thing is higher.
The reason was, the original version limited the usable printable high to 200mm. The new version allows to use full printing space 210x210x205mm
If you do not use maximum high, you can continue use this version. But for new prints, or to exclude the limit, use the new design.
Cable and bowden holder for Anycubic Mega /Mega S. Easy to print and use. It prevents cable and bowden contact with ramp, when the printed thing is higher.
IJK_CZ también publica en
3 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
