Thingiverse
Support Cube
von LauriLauter
3
Downloads
2
Likes
0
Makes
This is a simple 10mm cube with 1mm fillet all around. I use this as support in Cura.
Just add it to whatever you are about to slice > scale and move as needed > select - print as support.
Just add it to whatever you are about to slice > scale and move as needed > select - print as support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!