Thingiverse
support for lithophane
von JanRobin
0
Downloads
0
Likes
0
Makes
lithophane support/stand
Use a 0.6mm hotend.
It`s only 1-2 layer thick after the foot part, only scale in Z (height).
Goes down to about 16cm and up to 40cm, the spikes will get bigger or smaller depending on the scale.
cura says its 61grams, make a copy and mirror it, stick the spikes near the flat side on the lithophane., break or cut off.
Use a 0.6mm hotend.
It`s only 1-2 layer thick after the foot part, only scale in Z (height).
Goes down to about 16cm and up to 40cm, the spikes will get bigger or smaller depending on the scale.
cura says its 61grams, make a copy and mirror it, stick the spikes near the flat side on the lithophane., break or cut off.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
