Slicer Discord
Support Free Cyclops - 75mm Base – 3D-Druckmodell von MakerWorld MakerWorld

Support Free Cyclops - 75mm Base

von LeeKoopa
0 Downloads
1 Likes
0 Makes
Zum Modell
Behold the cyclops! This one eyed giant towered above the heros of greek mythology, until “Nobody” blinded him. These minis have been designed and tested to print without supports on an A1 mini. All designs done by hand without the use of a.i. Cyclops Sentry Huge Giant, Chaotic Neutral AC 14 Initiative +0 (10) HP 138 (12d12 + 60) Speed 40 ft. ModSaveSTR22+6+6DEX11+0+0CON20+5+5 ModSaveINT8−1−1WIS6−2−2CHA10+0+0 Senses Passive Perception 8 Languages Giant CR 6 (XP 2,300; PB +3) Actions Multiattack. The cyclops makes two attacks, using Stone Club or Rock in any combination. Stone Club. Melee Attack Roll: +9, reach 10 ft. Hit: 16 (3d6 + 6) Bludgeoning damage. If the target is a Huge or smaller creature, it has the Prone condition. Rock. Ranged Attack Roll: +9, range 30/120 ft. Hit: 22 (3d10 + 6) Bludgeoning damage. Reactions Limited Foresight (Recharge 6). Trigger: A creature the cyclops can see makes an attack roll against it. Response: The cyclops imposes Disadvantage on the roll, and the cyclops gains Advantage on attack rolls against the target until the end of the cyclops’s next turn.
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen