Support Free Telescopic LightSaber

by Josh3D · Other Toys & Games

107 Downloads

20 Likes

33 Makes

This saber is 100% support free. The handle is split in two where the chamfer starts. when these pieces are joined its very hard to see the seam. You will insert the printed saber into the bottom handle and the top handle will slide over the top. Then you can glue the top handle to the bottom. Be careful not to get superglue onto the saber itself or it will not fully extend.I wanted to make this saber longer than my previous, it extends to over 3 feet long.There is also a display stand that i made specifically for this saber.