Thingiverse
Support Settings Tester
por Elos
5
Descargas
11
Likes
1
Makes
This a small object I created in Fusion 360 to test support settings of your slicer. I tried to include some case where support is crucial:
- Print mid air
- slope to wall, slope away from wall
- round top
- print on object
- Print mid air
- slope to wall, slope away from wall
- round top
- print on object
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
