Thingiverse
Support Test Stand
par JohnOCFII
5
Téléchargements
8
Likes
0
Makes
Two simple models to test different slicer support settings.
Sometimes supports are easy to remove, sometimes difficult to remove. Sometimes they leave marks. Use this simple model to test different support settings. Prints at 0.20 layer height in about 30 minutes on a Prusa MK3.
Added circle test. Removing supports from the bottom of the circle has proven difficult!
Sometimes supports are easy to remove, sometimes difficult to remove. Sometimes they leave marks. Use this simple model to test different support settings. Prints at 0.20 layer height in about 30 minutes on a Prusa MK3.
Added circle test. Removing supports from the bottom of the circle has proven difficult!
JohnOCFII publie également sur
39 modèles supplémentaires sur 1 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !