Thingiverse
Support Test
von Trentbad
0
Downloads
0
Likes
0
Makes
Small test part built from the ground up to challenge your printer to make good supports.
Part size is 30X35X12 and can be printed in about one hour.
If your slicer doesn't place it correctly make sure the logo is face up.
I originally got the idea from https://www.thingiverse.com/thing:2823038 but wanted a bit more challenging print including spheres and curved surfaces.
Part size is 30X35X12 and can be printed in about one hour.
If your slicer doesn't place it correctly make sure the logo is face up.
I originally got the idea from https://www.thingiverse.com/thing:2823038 but wanted a bit more challenging print including spheres and curved surfaces.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
