Supportless Tux (Linux Penguin Mascot)

Fully printable without supports! I chose to use a brim for my prints, but it is not strictly necessary. Mine used 10% infill in a Gyroid pattern in PLA+ at 0.1mm layer height, scaled so it is 100mm tall (around 4 inches) and 2 walls / perimeters. At those settings, it only consumes 38 grams of filament.

Have fun!

Differences of the remix compared to the original model

I made the bottom flat for better adhesion and to make it set better on flat surfaces. I also added a tiny bridge on each flipper at its lowest point to connect it to the body and/or feet so the printer doesn't try to print mid-air. Minor geometry change to upper lip / edge of beak to prevent printing mid-air.