Slicer Discord
Sur-ron mudflap clamp / mudguard – 3D-printbaar model van Thingiverse Thingiverse

Sur-ron mudflap clamp / mudguard

door millenium7
38 Downloads
40 Likes
1 Makes
Model downloaden
This is a clamp to make a mudflap for the Sur-Ron electric bike to protect the rear shock and linkage. Designed with a lip to prevent the material folding into the linkage and making contact with it

Cut up something (I used a rubber tile) and use the clamps to secure it to the bike. You use the 2 existing bolt holes in the swingarm and the 2 existing posts at the back of the tail light to secure it in place

You will need
- 2x longer M5 Bolts (25mm?)
- Optionally a couple washers
- Some sort of material such as a rubber tile. Cut to approx 280mm x 130mm or thereabouts
(I'm using 300mm x 130mm in the picture but it is a bit too long. Can be shorter as long as it allows full shock travel. Install it with the bike on a stand to verify)

There are 3 base files that have different angles, the difference is shown in an image above.
Closest visually looks the best, but I was getting a little bit of rubbing at full compression and this could cause the paint to eventually wear
Furt
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
uitgebreide nabewerking
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Schilderen, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie