Surface Duo Bumper (full)

It is a left and right set of bumpers for Surface Duo.

・Assuming TPU filament.
・Because it is 15cm x 15cm in size that can be printed with a 3D printer, it is about 1mm smaller than the genuine bumper.
The right bumper has no back part so that the Surface Duo goes into single-sided mode when folded backwards.
・There is a hole for attaching a strap on the lower left corner of the left bumper.
・Attach with double-sided tape. I used Nichiban's double-sided tape for leather, rubber, and plastic. After attaching the double-sided tape to the Surface Duo, peel off the release paper and press the bumper to make it easier to paste.
・I also attach the data of the charging port cap. Please paste it with double-sided tape as well.


・Extruder Temperature 220℃
・Platform Temperature 50℃

Layer Height
・Layer Height: 0.30mm
・First Layer Height: 0.30mm

Speed
・Base Print Speed: 20mm/s
・Travel Speed: 10mm/s
・Minimum Speed: 5mm/s
・First layer Maximum Speed: 5mm/s
・First layer Maxim