Thingiverse
Surface pro 2 (gen 2) mounting clip
door suveck
1
Downloads
2
Likes
0
Makes
The hole for a nut is sized for an m4.
For fit be aware it may vary with your filament.
I printed this in ABS and it was so snug it extended the model by 0.5 mm(contained file is the extended version)
If printing in PLA, the model may need to be shortened slightly due to the differences in shrink rate.
3+ perimeters, high infill recommended
This could be attached to anything with a m4 bolt, I personally drilled a hole in a C-clamp I had and bolted this mount to that.
For fit be aware it may vary with your filament.
I printed this in ABS and it was so snug it extended the model by 0.5 mm(contained file is the extended version)
If printing in PLA, the model may need to be shortened slightly due to the differences in shrink rate.
3+ perimeters, high infill recommended
This could be attached to anything with a m4 bolt, I personally drilled a hole in a C-clamp I had and bolted this mount to that.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!