Thingiverse
Surface Pro - Recharging Station
door alpokemon
23
Downloads
14
Likes
1
Makes
This is a charging station for the Microsoft Surface, Surface Pro 3 or any computer that is thinner than 25mm. My Surface devices are all encased in the UAG Urban Armor gear so - extra thick.
It has 3 slots so you can use it to hold 3 devices at any given time. I have 3 Surface devices and I hate laying them ontop of one another to charge. The holes are designed so the charging wires can run through the bottom through the hole to the devices to charge. The holes are also going to try and stop the wires from falling through all the time. I may add more holes if needed.
This thing is huge and takes up 95% of the build area of my Makerbot Replicator 5th gen. Printing at 10% infill at .2mm will take about 18 hours! So, this is a long print. I am printing in draft mode and it will take 6hrs.
Also, glue 2mm foam to the bottom so it slides around less.
It has 3 slots so you can use it to hold 3 devices at any given time. I have 3 Surface devices and I hate laying them ontop of one another to charge. The holes are designed so the charging wires can run through the bottom through the hole to the devices to charge. The holes are also going to try and stop the wires from falling through all the time. I may add more holes if needed.
This thing is huge and takes up 95% of the build area of my Makerbot Replicator 5th gen. Printing at 10% infill at .2mm will take about 18 hours! So, this is a long print. I am printing in draft mode and it will take 6hrs.
Also, glue 2mm foam to the bottom so it slides around less.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
