Thingiverse
Suspended lamp
door Jhann81
41
Downloads
30
Likes
1
Makes
Inspired by Flos Aim Hangling Lamp / Flos Aim Suspended Light (designed by Ronan & Erwan Bouroullec, 2013).
Gu10 fitting. Will work with Philips Hue / Signify lamps (Zigbee signal not blocked).
Hood printed with ASA Jet Black, 10% infill, 2 perimiters, alligned layers.
Small parts (lamp mount etc) printed with ASA Jet Black, 10% infill, 2 perimiters
Reflector printed with ASA white, 10% infill, 2 perimiters.
Lens printed in PVB, 100% infill (only a few layers).
Printed hood and reflector in ASA for heat resistance (wasnt sure if PLA would hold up over time with a GU10 LED light inside). Hood and refelector need to print in an enclosure to avoid warping. Enclosure was 40deg C when printing and worked fine (have done multiple hood prints).
GU10 fitting, ceiling mount, cord, and cable brackets sourced from DIY lamp shop, but easy to design / print if so required.
Gu10 fitting. Will work with Philips Hue / Signify lamps (Zigbee signal not blocked).
Hood printed with ASA Jet Black, 10% infill, 2 perimiters, alligned layers.
Small parts (lamp mount etc) printed with ASA Jet Black, 10% infill, 2 perimiters
Reflector printed with ASA white, 10% infill, 2 perimiters.
Lens printed in PVB, 100% infill (only a few layers).
Printed hood and reflector in ASA for heat resistance (wasnt sure if PLA would hold up over time with a GU10 LED light inside). Hood and refelector need to print in an enclosure to avoid warping. Enclosure was 40deg C when printing and worked fine (have done multiple hood prints).
GU10 fitting, ceiling mount, cord, and cable brackets sourced from DIY lamp shop, but easy to design / print if so required.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
